AC110V 220V To DC 5V 12V 24V Single Output S-35 Series Switching Power Supply
Note:
1. The testing condition for the paramenter above is: 230VAC input, rated load, 2570% RH. Humidity.
2. Error. Include the setting error, line stability and load stability. (Note: 5).
3. Wave test: Adopting "A12"double wire for 20MHz, and 0.1UF&47UF capacitor short-circuit for interrupting.
4. Inlet voltage stability test: When is over load, the lowest voltage of inlet is up to the highest voltage.
5. Load stability test: The load is from 0% to 100%.
Model | S-35-5 |
S-35-12 |
S-35-15 |
S-35-24 |
DC output voltage | 5V |
12V |
15V |
24V |
Output voltage error(Note,2) | ±2% |
±1% |
±1% |
±1% |
Output current rage | 0-7A |
0-3A |
0-2.4A |
0-1.5A |
Wave and noise(Note ,3) | 75mVp-p |
100mVp-p |
100mVp-p |
100mVp-p |
Inlet stability(Note ,4) | ±0.5% |
±0.5% |
±0.5% |
±0.5% |
Load stablity (Note ,5) | ±1% |
±0.5% |
±0.5% |
±0.5% |
DC output power | 35W |
36W |
36W |
36W |
Efficiency | 70% |
76% |
78% |
78% |
Adjustable range for DC voltage | +10,-5% |
+10% |
+10% |
+10% |
AC input voltage range | 85-132VAC/170-264VAC Selected by switch47-63Hz,240-370VDC | |||
Input current | 0.5A/115V 0.25A/230A | |||
AC Inrush current | Cold-start current15A/115V 30A/230V |
|||
Leakage current | <0.5mA/240VAC | |||
Overload proctection | 105%-150%Type:Foldback:current limiting reset:auto recovery | |||
Over-voltage protection | ...... | |||
High-temperature protection | ...... | |||
Temperature coefficient | ±0.03%/°C(0-50°C) | |||
Setup rise hold up time | 200ms,100ms,30ms | |||
Vibration | 10-500HZ,2G 10min,/1cycle,Period for60min,Each axes | |||
Withstand voltage | Input and output internal,1.5KVAC,Input and enclosure,1.5KVAC,Output and enclosure0.5KVAC | |||
Working temperature and humidity | -10°C~+60°C(Refer to output derating curve),20%~90%RH | |||
Store temperature and humidity | -20°C~+85°C.10%~95%RH | |||
Overall dimension | 129×98×38mm | |||
Weight | 0.4Kgs | |||
Safety standards | Meet UL 1012 requirement(Not apply for the mark) |
1. The testing condition for the paramenter above is: 230VAC input, rated load, 2570% RH. Humidity.
2. Error. Include the setting error, line stability and load stability. (Note: 5).
3. Wave test: Adopting "A12"double wire for 20MHz, and 0.1UF&47UF capacitor short-circuit for interrupting.
4. Inlet voltage stability test: When is over load, the lowest voltage of inlet is up to the highest voltage.
5. Load stability test: The load is from 0% to 100%.